It is used to protect the horizontal joints between sheets of siding from water infiltration.
Z bar flashing installation.
The seat dimension 3 8 in corresponds to the siding thickness.
Check out our recommended tools right here.
Galvanized steel unless specified.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Z bar design easily accommodates rigid insulation.
Install the first length of z flashing.
If only the surface is damaged.
How to install z flashing on rotted t1 11 siding 1.
Subject to inquiry for availability.
Flanges are available in lengths of 1 1 1 1.
Place the z flashing into position on top of the casing.
Thd sku 686080.
When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the.
Designed for roofing applications.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
Item 3807 model 5504900120.
Suitable for residential or commercial use.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
Backleg made of 28 gauge galvanized steel.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
